DIY Coin Mech Programmers. Our NEW Programmers enable service personnel to re-calibrate a wide range of over 50 models of coin mechanisms to accept new coinsets. Connected to a PC or laptop it is highly portable, easy to use and lo. The classic coin pusher is one example that’s been a staple of arcades around the world for decades, and now you can build your own with this handy DIY kit. If you’re not familiar with the game, it works something like this: players drop coins through a Plinko-like slot so that they land on a platform crowded with other coins. As you can see, this improved DIY Coin slot mechanism for homemade vending machines is smaller than the previous version, also it uses less room and the size of the coin that will be accepted can be adjusted. Here is a video that shows how it works: Thanks to Noe Flores from California for sponsoring this project. In general, the coin slot mechanism is housed to one side on the top of the washer and is either the upright type or the sliding type, the dial type being more common on dryers. First, remove the coin store tray, empty it and check if there is anything obvious in the coin shoot inside. Coin Slot Mechanism Li'l Medic 4 Column LM4 3&4 SLOT COIN MECH DS. This is only for the coin mechanism Dual Door Locks with Lockable Coin Box.
cobradvs
New member
- Joined
- Dec 20, 2019
- Messages
- 4
- Reaction score
- 0
Diy Coin Slot Mechanism Hardware
The response I had on my first issue (monitor related) was very helpful! Hoping I can get another bit of advice. I have a couple issues with my coin slot assembly. Both are probably easy fixes, but obviously this is new to me..
1) Burnt out lights - The LEDs are definitely burnt out. Where can I get replacements? I've heard superbrights.com has them but I'm not quite finding something that looks like mine. Picture of the bulb and housing attached....this seems like a bulb that I could find at a hardware store but I don't know the required size/specs. FYI, this will be in an Coin Acceptors Inc. assembly. Seems they were bought by Happ? Picture of the assembly also attached, as mentioned in issue 2.
2) Stuck Coins - Quarters are getting stuck. There's a picture below where they're getting stuck. The blue line is the path the coin takes once inserted, the red circle is where the coin is stuck. It seems they're stuck on the brass lever...the coin reject button works just fine and I know the end mechanism (switch?) that adds the credit works, I just can't figure out how to get it to accept a coin. The front door does say 25C on it as well, so it seems it should be set for US quarters.
Any help is appreciated.